The problem addressed in this research is the opposite relationship between the , synchronous generator / compensator excitation voltage and the controlled voltage when nearby network is heavily loaded. In this situation, the nominal capacity of a generator / compensator would not keep the voltage controlled. Due to the opposite relationship, the higher the excitation voltage the lower is the controlled voltage. So, the automatic control would continue acting lowering the voltage. This mechanism, verified in a real operational point of the Brazilian Electric System, can lead the system to collapse. This phenomenon occurs when the power injection into the network is high. It is prone to occur in the new scenario of distributed generation connected to already existing low voltage networks. The objective of this work is to understand the actual operative situations that lead to the occurrence of the phenomenon, mainly when there are several voltage control devices nearby the generator. The analysis of the problem was based on the verification of the generator behaviour as a voltage control device, in time domain simulation and in steady state. The control actions were evaluated from seven different ways for operating points in the normal and the abnormal region of the SV curve. The actual existence of the phenomenon was proven through some of these analyses. However, some of the time domain simulations did not evaluated the phenomenon completely. Among them, the aggregated dynamic analysis and the aggregated dynamic analysis under influence of other voltage control devices have not got the expected responses for the abnormal region of the SV curve, in comparison with other analysis.